Charging Post Z5 7kw light guide column section

Overview: 7kw AC Charging Pile ；New Energy Car Charging Gun ;Ev Charger Pile ;

APP start charging:Turn on the power to the Charging Pile, and the indicator light is always on white after the equipment self-test is completed, indicating that the charging pile is in normal idle state.
Connect the charging gun to the charging port of the electric car, the indicator light is always on in blue, indicating successful connection，Use Cloud Fast Charge APP or WeChat or Alipay small program, scan the charging QR code on the charging pile, follow the operation steps prompted by APP to start charging, the indicator light flashes green, indicating that it is charging.
APP end of charge：
Click "stop charging" on the app or press the button to stop charging
Disconnect the charging gun from the vehicle connector and put it back in place, charging is end.

Product Name：Charging Post Z5 7kw light guide column section

Model：CW-JL-Z5

Specification：CW-JL-Z5/258.9X396.7X133.8 PCoperating version（APP）

Charging mode：Two-dimensional code scanning charge

Means of communication：5M (optional non-standard length)

human–computer interaction：RGB light strip

Rated Voltage：Single-phase three-wire 220VAC

Rated power：7KW(220VAC)

Working Frequency：45~65Hz

Max. Rated Current：32A

Operating Temp：-40℃～＋50℃

Protection Class：IP65

Number Of Jacks：New national standard 7 holes

General Standard：GB/T 18487.1-2015，GB/T34657.1-2017;

Warranty：One-year replacement, three-year warranty, lifetime maintenance

Protection function：Under-voltage, over-voltage, over-current, over-heat, short circuit, leakage, full automatic stop, ungrounded protection.

Precautions：

1, when installed in open-air places, it is recommended to be equipped with electrical boxes. 
2. Make sure the ambient temperature is between -20 ° C and + 50 ° C. Keep away from open fires or baked goods and avoid high temperatures.   
3. There should be no strong vibration, inflammable and explosive materials near the installation site, and good ventilation. Shall not be placed in corrosive, corrosive or humid air. Adequate space for cooling and ventilation must be reserved.  
4. The installation shall not be located in low-lying areas or in areas prone to water accumulation. The installation site shall not be higher than 2000m above sea level.
5, bracket installation without wall support, it is recommended to use wall-mounted installation, if the use of floor-mounted bracket, fixed installation. Pile installation, should ensure that the pile vertical, and avoid vehicles may pass the route.